Wire Crimping Support

The wires for many of the Trekker sensors require crimps to be installed so the sensors can plug directly into the Trekker OOPic Expansion Boards.  Some of the sensors require wires to be soldered to them. 

If you wish, you can select the addition(s) to have SuperDroid Robots crimp, solder or both for you.  If crimping is selected as an addition, you will not need to do any crimping.  If soldering is selected, you will not need to do any soldering.

The crimping is done using a crimping tool, or can be done using a pair of needle nosed pliers as per the pictures below.

A typical soldered sensor is shown below.