No other Robot kit offers this - an interface card to allow plug and play with your Robot! This package includes an assembled custom circuit board with all the component and the hardware to interface with an OOPic II MCU. The unassembled circuit board can also be purchased with all the items listed below loose. The hardware to mount this board on the OOPic II and Trekker Chassis is sold with the Trekker Chassis.
No corners were cut with this package. It contains the best components to give you reliable long lasting operation. The board allows the following:
(1) 40 pin header and ribbon cable to connect to the OOPic.
(5) Connections for servos with filters to avoid feedback noise.
(3) Connections for the Sharp GP2D12 IR detector.
(3) Connections for the SRF04 Ultrasonic ranger Ultrasonic Rangers.
(2) Potentiometers read by the OOPic A/D which can be used for tuning.
(1) Connection for an LCD module.
(2) LEDs controlled by the OOPic.
(1) Powerful 1.5A 5VDC for the OOPic and is filtering for clean reliable power.
(1) Powerful 1.5A 6VDC regulator for the servos with a heat sink and its filtered.
(1) Power LED.
(1) Piezo beeper for audible indications.
(1) Location to mount type 1 connector with our RS232 to TTL converter
- Fused battery connection.
- AC power jack.
- Voltage divider for reading input voltage with the OOPic A/D supplied to the board (battery voltage) prior to step down.
(40) Connections for every OOPic Pin for user expansion.
Please note this is set up different than the OOPic-R Expansion Card.
|
|
|
|
|
Labeled Expansion Card |
Assembled Expansion Card |
Assembled expansion card with OOPic and batteries sold separately |
