Communicate with and program your micro-controller, wirelessly, with our USB wireless system. The unit plugs into your PC via a USB port and then transmits and receives data to/from you microcontroller. Our mobile transceiver board has two regulators (3.3V and 5V) to allow communications with either level TTL device. Status LEDs at both transceivers let you know the wireless link strength, status, and activity for Tx and Rx. We have set up the wireless transceiver board specifically to allow a quick and easy interface with your TTL microcontroller whether its 3V TTL or 5V TTL. It works great with the OOPic II Plus or OOPic-R.
The system operates on 2.4GHz and has multiple channels that can be used. We have used these with no issues/interference and we have wireless routers, phones, and cameras running at the same frequency. Indoors the unit gets better than 300 feet of reliable range, outdoors you can achieve up to 1 mile line of site. The system is FCC compliant and operates using the following:
- ISM (industrial/ scientific/medical) 2.4 GHz operating frequency
- 60 mW (18 dBm), 100 mW EIRP power output (up to 1 mile range)
- Approved for use in the United States, Canada and Europe
The wireless module is a ZigBee/IEEE 802.15.4 compliant solution that satisfies the unique needs of low-cost, low-power wireless networks. The modules are easy-to-use, require minimal power and provide reliable delivery of critical data between devices. We use the xBee-PRO modules. Due to the innovations stamped in its design, the XBee-PRO yields 2-3x the range of standard ZigBee modules. Our system takes the xBee-PRO and adds an interface to allow you to quickly set up a wireless link with your microcontroller so you can upload programs, monitor, or control you microcontroller wirelessly.
The 2.4GHz ISM Wireless system replaces the physical serial cable by establishing a 'transparent' wireless link between your micro-controller/Serial Device and your wireless enabled PC/host device. So if you need to communicate with your mobile robot, remotely, our wireless system is an easily implemented solution.
For Further Support of this product, including operation, hookup, etc see our Wireless Serial Support Page.
Each USB kit has the following components (with default options selected):
| Qty |
Description |
| 2 |
2 Pos Connector housing with tabs (for power hookup) |
| 2 |
4 Pos Connector housing with tabs (for serial hookup) |
| 1 |
2 Pos Connector housing without tabs (for power hookup) |
| 10 |
Crimp terminals for tabbed connectors |
| 6 |
Crimp terminals for non-tabbed connector or to just stab onto a std square pin |
| 6 |
Heat shrink pieces to go over crimps if they are not inserted into housings |
| 1 |
Hookup wire |
| 4 |
Machine screws for mounting mobile transceiver |
| 4 |
Nylon spacers mounting mobile transceiver |
| 6 |
Machine nuts for mounting mobile transceiver |
| 1 |
XBee PRO USB Package. antenna, USB Cable, CD. Documentation. This kit does NOT include a power transformer as pictured, its not needed - power comes from the USB port/hub. |
| 1 |
Mobile Transceiver. This includes the XBee PRO module, SuperDroid Robot RF Interface Board (assembled and tested). |
