SportBEC (Battery Eliminator Circuit) powers your receiver and servos much more efficiently than a standard BEC. As many as 8 servos can be powered without worrying about an overheating BEC. SportBEC works great up to very high voltages, and is especially suited for "sport" aircraft and glow conversions. SportBEC is usually a necessity at 4s and above when running high torque or digital servos.

SportBEC's output is selectable between 5V/6V using a small slide switch. The 6V setting gives more speed and torque to the servos, and is especially useful for helicopter flyers. A red LED indicates when 6V is selected.

We use these BECs in our robots for powering our control systems that have high current demands. We will hook up IP cameras, wireless bridges, microcontrollers, etc. and the BEC has no problem with the current demand. Great source for servos too. Since its a switching supply we eliminate the need for multiple batteries, we run everything off of a single 24V source using the BECs for the control and servos instead of having a separate battery or batteries.

Because it is an efficient switching regulator, SportBEC can supply its full rated current of 3.5A all the way up to 33.6VDC.

SportBEC installs between your ESC and receiver, so you don't have to modify your speed control to disable its internal BEC.

For best results, ensure that the SportBEC is installed at least 2 inches away from your receiver and antenna.

Additional notes: If you are using small servos make sure they can run at 6v. Some sub-micros, notably the Hitec HS-50 and Futaba S3154, can be damaged by a 6v supply.