Packing

• 22.2 V 10 Ah pack is made by 6 pcs High power Polymer Li-Ion cell of 3.7V 10000mAh batteries with 50Amp drain capability
• Wrapped by heavy duty heat shrink tube
• Built in Protection Circuit Module for 6 Cells

• 22.2 v (working), 25.2 V ( peak), 15V ( cut-off)

• 10000 mAh (222 wh)

• One PCM with balance function is installed in the battery pack to balance charging and protect battery module from
  • Overcharge beyond 25.2V
  • Over-discharge below 15V
  • over drained beyond 45A
  • Must wait min of 30 minutes after battery is fully charged to allow the pcm to perform balance function on all the cells within the pack.
• Charging terminal: 6" 20 AWG with tamiya male connector.
• Discharging terminal: 6" 12 AWG open end wire.

• 40 Amp limited by PCM

• 160mm (6.3") x 76mm (3.0") x 72mm (2.8")

• 3.3lb (1496g)

• Please use smart charger below.
  • You may use 1.5A Smart Li-ion battery charger with 8.0 hrs charge time.
• Must plug the charger and the connector adaptor via only charge terminal with correct polarity.
• SuperDroidRobots.com will not be responsible for any damage caused by misusing. Read our Terms.

• Please note this battery is for R&D use only and NOT for individual customers. We are not responsible for any damages or losses caused by using battery pack.
• Please never discharge the battery pack beyond its Max. rating
• Must read before place an order. We reserve the right to not sell the battery to any one if we feel they cannot handle Li-Ion battery safely
• For safety warning please see the link here

• Limited Warranty: Repair or exchange only within 15 days.