This is the deluxe version of our robot power distribution modules. The module features support for two independent drive and control batteries as well as additional power output connections. Perfect for solutions requiring much more power. The module features screw terminal connectors for your control and drive batteries, charging, power switch, and external LED. A low current switch can be wired to the designated switch header to control the smaller 10A relay. The adjacent LED header is equipped with a 1k resistor so an external LED can be wired directly to the circuit board.
The 10A relay supply power to (10) 0.100" friction lock headers. An optional connector kit can be found on the bottom of this page. The 30A relays have (5) high current outputs with 5.0mm screw terminals. The 30A relay also supplies power to (2) additional low current 0.100" friction lock header.
The 30A relay's coil is brought out to the adjacent header. This can be connected to the output of the 10A relays or a high current driver (TE-010-800) can be used to control the relay with a microcontroller like an Arduino.
Included in this Kit:
These are high quality sealed Single Pole - Single Through (SPST) relays. This relay's coil is rated for 24V.
These are high quality sealed Single Pole - Single Through (SPST) relays. This relay's coil is rated for 12V.
This is a MLT-42-F tracked robot platform and is equipped with flipper arms, 42mm motors, a motor controller, and FLYSKY remote control. This rugged robot platform the treaded robot handles up to 15lbs of additional payload and travels 134ft/min.
This is a prebuilt RC lawnmower. It is fully assembled and tested and includes the electric mower. This is our Rev 2 Mower chassis. It is faster, more powerful, and has a longer run time.