This is a pair of All Terrain reinforced 4 inch wide matched treads for the HD2 Treaded Robot. These are the generation 4 design. They have 4 ply mesh reinforcement, molded rubber with no splice. If you want the wheels that go with these tracks, see our 4th generation HD2 wheel and track set.
The multi-ply treads have an aggressive black rubber all-terrain 4" wide pattern. The inside of the tracks have internal cleats that are used for positive timing to match the teeth on our HD2 wheels. The tracks also have UHMW guides that match taper on our generation 4 wheels which allow for better tracking and very low probability of derailing. This track does NOT have a splice! It is one continuous piece. The nominal center to center distance of these tracks with the HD2 wheels is 28.375". The weight of each track is about 5 lbs.
The tracks can also be ordered with a custom length. Please specify your total length in the item options below. A custom length will take up to 6 weeks to deliver. Determine your length of track you need for your robot, then divide that length by the pitch of our track. 1.89" Then you have to adjust the length of track to make the pitch come out to a whole number.
2 pairs (total of 4) of HD2 Track Wheels for the HD2 Robots.
This is a pair of All Terrain reinforced 4 inch wide tracks for UGVs. They have a mesh reinforcement, molded rubber with no splice. This is the same track used on our HD2 minus the guide cleats.
The GPS 18x is an OEM, high-sensitivity GPS sensor for use in automotive, fleet vehicle, and electronics applications that require a small, highly accurate GPS receiver.
Use these roll pins to fix sprockets to a shaft and keep them locked in place.