This chassis plate is used with our IG32 and IG42 custom length robot platform. Mount two custom length sides to this plate and you have a sturdy chassis ready for assembly with room to mount batteries and electronics.
Size the chassis according to your needs and the length of the motors. The width of the plate must be at least (the length the gear motors + 2" tube + 1/8" adaptor plate) x 2. You are responsible for selecting the correct size chassis. For motor lengths, see any IG32 or IG42 motor item page.
In the options below you can select between the standard size chassis (wheels 18" center to center x 14.75" wide) or a custom size. When selecting a custom size, use the wheel center to center distance of your tube and not the length of the plate. We will size it appropriately to fit your motor tubes. If you'd like a specific length, subtract 3.25 from the length you would like and enter it into the length text box. See the drawing in the image gallery for further clarification.
This chassis plate is used with our custom length robot platform. Mount the tubing frame to this plate and you have a sturdy chassis ready for assembly with room to mount batteries and electronics.
This is a 2" x 2" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot.
100 pack of black UV resistant nylon with flexible tape section, pull tight and does not come undone. Length 8 inches.
This is a Custom MLT-JR tracked robot platform, equipped with a pan and tilt camera for inspection purposes. It comes complete, a MLT-JR Tracked Robot Platform with PT Camera, LCD, Controller, 100ft tether, fully assembled and tested.