This is a customized version of the following robot kit: TP-045-000
It was built with a cutout in the center of the bottom plate. It also includes two cross tubes welded to the motor tubes to stiffen the chassis.
The tube structure uses sealed flange bearings to support the axle. The other side of the axle is supported by the motor. This provides a much stronger attachment for the wheels and the load is put on a heavy duty bearings and tube instead the motor. Direct coupling a wheel to the motor will just ruin a motor quickly.
Contact us if you need a custom configuration.
This is a 2" x 2" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot.
This is a basic Omni Wheeled Robot Kit that has all the main features to get you going. previously TP-091-001. Now available with Nexus wheels.
This is an Enclosed 4-wheel drive remote control robot kit. It uses four powerful wheelchair motors and the inside robot cavity has plenty of room for electronics.
100 pack of black UV resistant nylon with flexible tape section, pull tight and does not come undone. Length 11 inches.