This aluminum motor mount is designed to support any of our IG32 motors or IG42 motors. Use with our IG32 or IG42 motor mount plates, a motor plate hardware kit, and any of the following wheel and shaft sets:
Mount two of these and a caster to a piece of plywood, aluminum, or acrylic for a simple and inexpensive 2WD robot.
The tube structure uses the bearing linked above to support the axle. The other side of the axle is supported by the motor. This provides a much stronger attachment for the wheels and the load is put on a heavy duty bearings and tube instead the motor. Direct coupling a wheel to the motor will ruin a motor quickly.
This is a 2" x 2" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot.
This is a 2.5" x 2.5" x 4" long Aluminum tube with a 1/8" thick wall designed to support one of our IG52 motors.
SparkFun's minimal design approach to Arduino. This is a 5V Arduino running the 16MHz bootloader.
The DSP Beacon can be used in both the Non-Inverse Architecture (NIA) and in the Inverse Archicture (IA).