This aluminum motor mount is designed to support any of our IG52 motors. Use with our IG52 motor mount plate, any of the following wheel and shaft sets:
Mount two of these and a caster to a piece of plywood, aluminum, or acrylic for a simple and inexpensive 2WD robot.
The tube structure uses the bearing linked above to support the axle. The other side of the axle is supported by the motor. This provides a much stronger attachment for the wheels and the load is put on a heavy duty bearings and tube instead the motor. Direct coupling a wheel to the motor will ruin a motor quickly.
Includes the following hardware:
This is a 2.5" x 2.5" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot with IG52mm motors.
This is a 2" x 2" x 3" long Aluminum tube with a 1/8" thick wall designed to support one of our IG32 or IG42 motors.
This is a prebuilt MLT-JR tracked robot platform equipped with 12V 32-millimeter motors, a motor controller and an authentic Arduino for autonomous control.
This is a 4WD IG42 single bearing platform that is setup for outdoor navigation/positioning. A full array of sensor options including an IMU, motor encoders, and a Garmin 18x GPS that can provide position feedback with up to 3 meter accuracy.