This aluminum motor mount is designed to support any of our IG52 motors. Use with either of the following wheel and shaft sets:
Mount two of these and a caster to a piece of plywood, aluminum, or acrylic for a simple and inexpensive 2WD robot.
The tube structure uses the bearing linked above to support the axle. The other side of the axle is supported by the motor. This provides a much stronger attachment for the wheels and the load is put on the heavy-duty bearings and tube instead of the motor. Direct coupling a wheel to the motor will ruin a motor quickly.
This is a 2.5" x 2.5" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot with IG52mm motors.
This is a 2" x 2" x 3" long Aluminum tube with a 1/8" thick wall designed to support one of our IG32 or IG42 motors.
This is our prebuilt HD2-S robot modified with a 5 axis robotic manipulator arm. This robot is loaded with all the options including a programmable Arduino. Ready to ship. We will supply the Source Code.
900 MHz Rubber Duck Antenna - SMA Male Connector