This handy USB extension cable will make it easy for you to enclose a device that has a A type (USB host) port. We think this would be most handy when putting a Beagle Bone, Raspberry Pi or Mintyboost into a box.
The jack half has two mounting 'ears' with M3 screws installed, 30mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 8.25" long from tip to tip (with 5" cabling between USB connectors).
This handy USB extension cable will make it easy for you to enclose a device that has a micro-B type port. We think this would be most handy when putting an Arduino Leonardo or Raspberry Pi in a box.
3ft USB 2.0 A Male to Micro 5pin Male 28/24AWG Cable w/ Ferrite Core (Gold Plated)
900 MHz 3 dBi Rubber Duck Antenna - SMA Male Connector
This robot uses custom length sides and 13 inch tires with IG52 136 RPM motors. We have included everything to make it ready to run including batteries, chargers, and a controller.