This Carbon Monoxide (CO) gas sensor detects the concentrations of CO in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of 10 to 10,000 ppm.The sensor can operate at temperatures from -10 to 50°C and consumes less than 150 mA at 5 V. Please read the MQ7 datasheet (185k pdf) for more information about the sensor.
Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 10 kO.
We offer a Pololu breakout board that makes it easier to interface with these sensors.
This carrier board is designed to work with any of the MQ-series "gas sensors".
This semiconductor gas sensor detects the presence of Carbon Monoxide at concentrations from 10 to 1,000 ppm and combustible gas from 100 to 10,000 ppm.
This ATR robot uses custom length sides and 10 inch tires. We have included everything to make it ready to run including batteries, controllers, chargers, etc. It has been fitted with a custom top cover.
This is a direct drive 4WD programmable Arduino robot platform for indoor robotics. Using 4 Nexus mecanum wheels, it can vector in any direction.