Smart Charger for 4.8V - 10.8V NiMH and NiCad

  • Smart Charger for 4.8V - 10.8V NiMH and NiCad

Features and Specifications

  • Universal Fast and Smart Charger is designed for charging any NiMH / NiCd Battery Pack from 4.8V - 10.8V , e.g. 4 to 9 cells pack
  • One charger for all types of battery packs of RC airplane, RC car and Airsoft .
  • LED flashing red-green-red before charging in order to test the IC of the charger if ready to use.
  • It is a very smart charger. Just plug it in and wait for the battery to get charged. Red LED indicating charging, and Green LED means fully charged
  • Short circuit protection: No output voltage from the charger if the battery is not connected.
  • 120-240V AC input for worldwide use.
  • Detects battery pack voltage (from 4.8 - 10.8V) and chooses proper charging voltage automatically
  • Cuts off power automatically by negative delta V IC when battery pack is fully charged.
  • Built in IC Protecting battery from over current, short circuit & reverse polarity.
  • Two current levels, 2A and 1 A, are selectable by a switch for both high capacity ( > 2100mAh) and low capacity battery pack ( < 2000mAh)
  • For battery pack between 1000 mahr and 2000 mahr, please use the low level switch -- charging rate: 1 A
  • For battery pack over 2000 mAhr, please use the high level switch -- charging rate: 2A
  • The smart charger will cut-off power automatically when battery is full. However, Charging time can be estimated as the follow:
  • Time ( Hrs ) = Battery capacity (Ah) / Charging current ( 1A or 2 A )
  • Dimension: 1.5"H X 2.5"W X 5.5"L
  • Weight: 0.6 lb.
  • One standard female Tamiya connector with 12" length cable is installed with the charger.
  • One 5' cable with female connector and two clips which allow you to connect a battery pack to the smart charger.
  • one 4' cable with PC connector is included to connect charger to AC power.

Documentation and Support

Warning

  • Don't use the charger to charge battery pack with capacity less than 1000 mAh
  • If you have question on what current setting to use, please check the battery specification to find out what is the maximum charging current before selecting the charging current.
  • The charger is designed for indoor use only.
  • The charger should be horizontally positioned and works in well ventilated condition, avoid moisture and keep it away from flammable explosive goods.
  • Ambient temperature shall not be more than 40 degree C when using the charger
  • Remove the AC power before connect or disconnect the charger with batteries.
  • Don't try to disassemble the charger

Multi-Current Smart Charger ( 1-2 A ) For any 4.8V - 10.8V NiMH / NiCad Battery Packs


Smart Charger for 4.8V - 10.8V NiMH and NiCad

  • Product Code: TE-106-010
  • Availability: 19 In stock
  • $47.00



Related Products

Smart Charger Extra Temperature Sensor
Smart Charger Extra Temperature Sensor

Temperature sensor fow use with Smart Chargers...

Product Code: TE-107-000

$3.00 $4.99

Battery Box 4.8V (4 AA) w/BEC plug
Battery Box 4.8V (4 AA) w/BEC plug

This is a simple battery box 4.8V (4 AA) w/BEC plug.  This does not include the batteries.   Used to..

Product Code: TE-143-004

$4.32