The bases are laser cut to ensure exact match up of hole sizes etc for mounting parts on your ATR or Vectoring Robot. The bases are made of 0.125" thick Aluminum for high strength, light weight, and it won't rust. The bases can be stacked giving you lots of room for additional components.
An uppper polycarbonate deck can also be purchased. (The polycarbonate is clear)
The triangle sides would project out to be 12", but are rounded. All sides are equal. This is our small base. Only IG32 191 rpm motors can fit into the housings. For other IG32 motors or IG32 motors with encoders, our larger base must be used.
The aluminum base has predrilled holes for mounting the following:
The polycarbonate /acrylic deck is CNC cut to ensure exact match up with the lower deck. It includes 4" bolts and nuts for mounting the deck.
This is a MLT-42-F tracked robot platform and is equipped with flipper arms, 42mm motors, a motor controller, and FLYSKY remote control. This rugged robot platform the treaded robot handles up to 15lbs of additional payload and travels 134ft/min.
900 MHz 5dBi Rubber Duck Antenna - SMA Male Connector