The USB cable installs into your PCs USB port and installs as a COM port. Virtual COM port (VCP) drivers cause the USB device to appear as an additional COM port available to the PC. Application software can access the USB device in the same way as it would access a standard COM port. Today’s computers typically do not have RS232 ports on them anymore, this solves that issue by providing you a virtual COM port using the common USB port. The USB end of the cable contains a custom compact circuit board inside the housing.
The drivers can be downloaded from the FTDI site. First time installs will install 2 drivers before its ready to operate. You should only need to do this once per PC. Once installed you can remove and reinsert the cable without having to install the drivers each time. Go to your devise manager to determine what COM port was used. Its typically the next available COM port on your PC.
We also sell a variety of serial and USB converter cables with different types of connectors. However, if you need something custum, we can make cables to your specifications! Contact us with your requests.
USB to Open-ended Serial Cable, FTDI, 5V TTL.
Our USB to RS485 converter provides two way serial communications signal conversion between an RS485 device and your computer using a virtual COM port.
This prebuilt RTR robot uses our standard ATR chassis and 10 inch tires. We have included everything to make it ready to run including batteries, controllers, chargers, etc. Upgraded drive train with encoders on each motor set to speed control.
The MiniSLAM is a programmable autonomous robot built on the Robot Operating System (ROS). It is controlled using a USB gamepad and the ROS Visualization (RViz) application.