This aluminum motor mount is designed to support any of our IG32 motors or IG42 motors. Use with our IG32 or IG42 motor mount plates, a motor plate hardware kit, and any of the following wheel and shaft sets:
Mount two of these and a caster to a piece of plywood, aluminum, or acrylic for a simple and inexpensive 2WD robot.
The tube structure uses the bearing linked above to support the axle. The other side of the axle is supported by the motor. This provides a much stronger attachment for the wheels and the load is put on a heavy duty bearings and tube instead the motor. Direct coupling a wheel to the motor will ruin a motor quickly.
This is a 2.5" x 2.5" x 4" long Aluminum tube with a 1/8" thick wall designed to support one of our IG52 motors.
This is a 2" x 2" Aluminum tube with a 1/8" thick wall machined to a custom length. Using two of these you can make your custom sized robot.
This is a fully assembled, second-generation LT2 robot platform. We use the same chassis in our tactical LT2. It's similar to our HD2 treaded robot, but it's lighter.
This is a prebuilt version of TP-251-003, our programmable triangular omni wheel vectoring robot. It can vector in any direction and is great for indoor robotics. An Arduino Mega and encoders allow for this to be an autonomous robot.