Set of 3 Used IG32P 24VDC 075 RPM Gear Motors with Encoders - DISCONTINUED

  • Set of 3 Used IG32P 24VDC 075 RPM Gear Motors with Encoders - DISCONTINUED
I have been diced

**This is a set of three used gear motors that we used for research and development. The actual gear motors are pictured above. Please note that the wires have been clipped and modified on each motor. For these reasons, we're selling this pack of three for the price of two.***

These gear motors are made with steel gears (not plastic or sintered metal). They run great and we've tested them extensively on our All-Terrain- Robots and Vectoring Robots. We sampled many other manufactures and the gears would strip or the windings would burn up, we had no failures with these.

These gear motors have encoders mounted to the tail shaft of the motor. They are hall effect encoders that count the revolutions the motors make. Since its a two channel encoder you can detect the direction of rotation and pick up 4 rises and falls per revolution of the motor. Apply the gear ratio of the motor and any further reduction of your drive train to get total revolutions of your wheel, etc. Follow this link for a datasheet for the encoder.

We recommend controlling the motors with one of our motor speed controllers. See our motor controller support page for more information. We also recommend you use our wiring kit to wire your motors to control the electronic noise generated from any DC motor. See our motor wiring support page for more information.

The table below lists its characteristics. The images below show current and torque curves and dimensions. They utilize a 1:71 gear reduction. The gear motor is 24VDC.

Reduction Ratio Rated Torque Rated Speed Rated Current No Load Speed No Load Current
kgf-cm rpm mA rpm mA
1:71 8.0 190 <900mA 75 <450mA


Set of 3 Used IG32P 24VDC 075 RPM Gear Motors with Encoders - DISCONTINUED

This product is unavailable.

Contact us if you have any questions.