This is a Magnevation Dual Channel PWM (Pulse Width Modulation) Driver that easily interfaces with the OOPic. It can also be used with any other PIC that has PWM output.  It's Plug and Play for no solder operation.  Dual independent PWM Drivers designed for DC permanent magnet motors, incandescent lamps, solenoids, resistance heaters etc.  This unit operates on  12-55 Volts DC with drive current up to 3 Amps continuous per channel.  The standard unit also includes joystick port that utilizes standard PC style joysticks.   The Joystick can be hooked up using the joystick adaptor cable.  This unit also includes pass through connector for connecting other accessories to the system. 

For help selecting and wiring a motor speed controller, see our motor controller support page.

The LT board was just have released.  It is the same board as the standard board, but without the joystick interface, heat-sinks and option jumpers installed.  Since this board does not have these items, we can sell is cheaper if all someone needs is just for driving motors. 

• Power supply requirements - 12 to 55 volts DC 0- 3 amps per channel.
• Dual independent PWM channels, each channel is independently powered and fused  with speed, direction, brakes, thermal flag and analog output to indicate motor current.
• Based on Nation Semiconductors LMD18200T   H-bridge Driver IC's.
• Data Pass - Thru  design allow other accessories to be connected to the OOPic.
• Break out port  allows access to all 4 analog input channels on the OOPic as well as several important digital I/O channels.
• Break Out Port also doubles as a Joystick input port utilizing standard inexpensive joysticks and back plane headers used by Personal Computers.  The Joystick can be hooked up using the joystick adaptor cable.
• Small size, same as the OOPic 3.5" X 2.0"
• Circuit Board  is manufactured and assembled in the U.S.A. and is of the highest quality.  These boards are double sided, tined and plated thru holes, with solder mask on both sides, and parts legend on the top side.  The component holes are slightly larger than most other cards on the market to allow easy changes and modification by the end user.  These Assembled  boards have been electrical tested and  visually inspected prior to shipping.

For Further details, including pin out assignments, etc see Magnevation's specification page. 

Click on images for larger views
Magnevation Dual 3 Amp PWM	Magnevation Dual 3 Amp PWM	Magnevation Dual PWM LT