-
Brian Busby replied to the topic Sabertooth 2×32, kangaroo x2, IG42, encoders, etc in the forum Electrical & Controls 9 months, 1 week ago
Thank you for the quick response. Initially, my intention is the obtain speed control in RC mode. With the encoders aside, if I set the sabertooth dip switches to: 1,2 -off, 3,4,5,6- on and the kangaroo dips are all ‘on’, hook up the RC: 0v, 5v and s1 respectively…shouldn’t I have RC control?
Is there another product that you recommend instead…[Read more] -
Brian Busby started the topic Sabertooth 2×32, kangaroo x2, IG42, encoders, etc in the forum Electrical & Controls 9 months, 1 week ago
I am looking for some guidance here. My initial question is, “Do you have to use the Motor Encoder Pull-up board with the IG42 motor?” What is their purpose? (I purchased a couple already)
I have a Sabertooth 2×32 controller that I can control the IG42 motor with via RC. The problems start when I add the kangaroo. The motors just randomly “gi…[Read more] -
Brian Busby became a registered member 9 months, 1 week ago
SuperDroid Robots | Brian Busby
