Dave

Can you recommend chargers for the 4 bank, 2 array 24v 35Ah setup using Insterestat SLA batteries

In the Electrical Schematic of the WC800-DM4, it looks as if wires were doubled up including the 40 amp breakers. Could one safely get away with using 2 80 Amp breakers and use 10 awg wire instead of 12 awg? Not to mention fewer wires going to the motor controller.

Your help is greatly appreciated?

I am working on a project but would like you expertise on which drive method is the best. If it’s direct drive how did you attach the wheel hub directly to the axels as in the wc800-dm4?

If chain drive, can you direct me how best to do that with 4 wheel chair motors.

That you for your help.

I am hoping you can help me. I would like to be able to control 3 actuators as well as the motors from 1 transmitter. If that is possible, would it be possible to get a schematic of the electronics to do that? My current set up is using 4 12v 35a batteries using a saber tooth 2×60 connected to 4 jet 7 wheel chair motors.

Thank you for you time…[Read more]

What do you use for an on-board charger for the WC800-DM4 unit? I would like to incorporate a on-board charger on my unit, 4-12v 35Ah batteries as well.

This may be asked previously, but that data seem pretty old.

What is the best controller to run 4 jazzy motors; whether in mixed or seperate mode.