SuperDroid Robot User

In fact I sent you the packet that you asked about.. it doesn’t matter if in hex or decimal.

Thanks.. will try that.

Hi,
Sorry maybe misunderstanding..
The drive command is:

OK let me know the results of that test. And can you also show me the drive command packets you’re using? And when you say the robot doesn’t stop, does it just keep traveling at the last speed you sent it and then stop after 4 seconds or does it just slow down very gradually?

Thanks so much..
As mentioned I am not complaining of the other fun…[Read more]

No problem with drive commands.. all working fine. Only the stop command.

Stop command packet (8 bytes)
Stop: . it stops the robot but after 4 seconds while expected immediately.
I want to try USB, but I need to use a PC instead of Android app. Will try that tonight.

Hi,
Just like it starts immediately after sending the go command, I want it to also stop immediately after sending the stop command. Now it doesn’t.. it stops after 4 seconds or after traveling 1 additional foot. (1/4 speed)
I can send you the Arduino project by email if it can help..

Yes, 4 years.. but never used it. it’s in the original shape and very clean. after testing it I put it in the same box that it came in. Just opened it a few days again (see attached). I was outside the country for most of that period.
I suspect the timer interval but not sure. tried several values.

Hi,
Yes it was a custom design and you provided and programmed the BT for me.
Order# 47975, Date: 11/16/2016