This is our 2nd generation base ATR kit. The IG32 ATR and IG42 ATR bases are the same except for the motors they accept and the width of the chassis. The RC version and Base version are the same except for the options and additions available on the item page. Both the IG32 and IG42 chassis will support either 4WD or 6WD when using the standard ATR shaft and wheel sets.

It is an extremely rugged well built robot. The wheels are axle mounted and are supported using sealed ball bearings. The motors allow this robot to climb walls. The base is made of aluminum that is easy to drill mounting holes for your electronics. The kit provides you with what you need to make a great All-Terrain robot.

This is a rugged frame made of 1/8" thick aluminum to accept our IG32 and IG32P gear motors or our IG42 gear motors. This is our 2nd generation ATR frame and wheel housing. We took our previous design that had separate motor housings that mounted to a base and made it all one piece. We also stretched it slightly, adding the ability to make it 6WD. The aluminum frame is fully gusseted adding greater rigidity. The aluminum is all laser cut for an exact fit-up and then hand welded and polished. The robot can be configured for 4WD or 6WD when using the standard ATR shaft and wheel sets. If a 4WD is purchased it can be upgraded later to 6WD, just add the middle set of wheels and motors. See our ATR page for more details.

The IG32 ATR frame is 12.25" wide x 17.25" long. The IG42 ATR frame is 14.25" wide x 17.25" long. The sides are 2.125" high (bottom edge to top surface) for both frames. Note, these dimensions do not include weld filler, which adds a little to the overall dimensions. As configured with the standard ATR shaft and wheel sets it has a ground clearance of about 2 5/16" and total width (wheel edge to wheel edge) of about 21" for the IG32 frame and 23" for the IG42 frame. The length of each chassis about 21.5" (wheel edge to wheel edge). The overall height is just the wheel diameter of 6.75". See our ATR page for more details.

The standard items and options listed below. They are listed as links and can be clicked to view further details.

Don't forget to get your battery charger(s) either.

This item usually ships within 1-2 days depending on volume. Assembly adds a couple more days.