We had fun building this robot. He may look familiar… We started with MLT-JR custom length tracks and added a simple shell and head. The motors are driven with a Sabertooth 2×5 Motor Controller. All the parts (other than the drive train) were made with our 3D printers. Then we gave it a quick paint job. We embedded two IR sensors on the front and put a Arduino in the middle cavity to dr...
Read More »
We’re celebrating Arduino Day by cutting the price of all Arduinos, shields, and select breakout boards! This sale is valid until midnight March 28th (11:59:59 EST) and while supplies last (no backorders). Arduino Day is a worldwide event bringing people and projects together. On our blog we’ve shared some of our personal projects like an automated chicken coop and a beer dispensing sy...
Read More »
Today’s Tech Thursday topic is an explanation of how we make our shafts, sprockets and gears couple to motor output shafts. There are several different methods we use depending on the application. Here’s how we have the most success. Light Duty Torque Applications - Set screw to the flat side of the shaft. All of our standard motors have a D shaft. Either 6mm, 8mm, or 12mm. We drill out...
Read More »
Today’s Tech Thursday topic is using RC switches to hack your lawn mower for a remote start and stop. We’ve done this with our 4WD remote control lawn mower and our Remote Control snow blower. Here’s how we did it. We used the following components: Spektrum DX6 Controller with AR6210 Receiver Pololu RC Switch Relay Board (you can use a 5V relay) Servo pigtails The RC switch is needed to comm...
Read More »
SuperDroid Robots’ Keg-a-Droid aired on the Discovery Channel for St Patricks Day! The Daily Planet featured the Keg-A-Droid which we are running on a campaign for on KickStarter serving beer from our friends at the Aviator Brewing company. #Kegadroid #Kickstarter #DiscoveryChannel #AviatorBrew
Read More »
One of the most basic positioning elements of autonomous robotics is the encoder. These are attached to rotating points such as arm joints and wheel axles in order to determine distance of movement. We sell an array of our IG32, IG42, and IG52 gear motors with a hall-effect encoder option. How do they work? The picture above is a simple diagram of the hall-effect encoder found on the back of our m...
Read More »
Today for Tech Thursday we are discussing chain coupling for wheeled robots. Chain coupling allows for a better 4WD system even if you are already using a motor per wheel. This is because each wheel is powered by two motors. It won’t make a difference if you are driving on level terrain but if you start driving in rougher terrain where a wheel might come off of the ground it will help immensely. W...
Read More »
System Architecture Introduction: Yes I know, why automate a chicken coop? Well we just wanted to do a starter home automation project and one thing led to another and now I have the fanciest chicken coop around. Spoiled chickens lay good eggs… It also is because I am a little lazy and don’t want to get up every morning to let the chickens out and go out each night to close the coop. S...
Read More »
So we are hard at work doing testing. Soon we will have the refrigerated keg-a-droid… Check our our kickstarter campaign! Lots of momentum including a article from CNET. Join us for the party… #kegadroid #aviatorbrewing #kickstarter
Read More »
Lately we have been hard at work developing a new robotic beer servant named Keg-a-Droid; you can check out our Kickstarter campaign. Keg-a-droid is a remote controlled, mobile robot equipped with a keg and tap system and this week’s Tech Thursday will demonstrate some components of the beer dispensing control system. More specifically, this is the test setup we used to calibrate our flowmeter out...
Read More »