LT2 Arm additional information

[shoogyParticipant]

Hi,
As part of my Mechanical Engineering project i decided to integrate your LT2 Multi-Axis arm in my design.

I need additional information regarding to the arm specs, The Arm Power consumption (Watts) and general electric information (Voltage and current).

[SuperDroidKeymaster]

Hi. The design details of the design are proprietary. It requires 24VDC and you should have capacity up to 25 or 30Amps (that would be extreme - fully loaded). When the arm is just sitting there, only the control board will pull power (couple hundred miliAmps). Each joint is only a couple amps without a load. All you need to do is supply the power, the arm comes completely wired and configured. A serial signal (we provide the protocol) is used to control the arm. If you would rather we can make it RC signal (in which case you would have a RC signal for each axis).

[Author]

Posts