• Universal Fast and Smart Charger is designed for charging any 19.2V - 24V NiMH and NiCd Battery Packs with capacity > 1500mAh (16-20 Cell packs)
• It is a very smart charger. Just plug it in and wait for the battery to get charge.
• 100-240V AC input for worldwide use.
• The charger cuts off power Automatically by negative delta V IC when the battery pack is fully charged.
• Protection fuse for over current, short circuit & reverse polarity protection.
• Battery will be charged at 1.5A constant current
• Charging time can be estimated as the follows:
  • Charging time ( Hrs ) = 1.2x Battery capacity ( Ah) / 1.5
  • For 3 Ah battery pack, charging time is about 2.5 hrs.
  • For 13Ah battery pack, charging time is about 10 hrs.

Dimensions:

• 2.0"H X 2.7"W X 5.8"L.

Weight:

• 15 OZ.

• One standard Tamiya male connector installed with the charger.
• One set connector adaptor from female tamiya to Clips is included for charging any battery pack.
• One temperature sensor (70 C thermister) is included for battery packs that don't have thermostat protection. It must be connected between battery charger and the battery pack before charging to protect battery from overcharging. It will cut-off power if battery temperature is over 70 C
• How to use Temperature sensor:
  1. Attach temperature sensor to battery pack inside firmly --- you can use electronic tape or glue to attach the sensor to the battery's surface
  2. Plug (red, BEC ) connector into the temperature socket into the charger

Manual:

• Please click here to download specification

Precautions:

• Please don't use the 19.2V-24V charger for charging battery packs with voltage <19.2V or voltage >24V and capacity <1500 mAh
• The charger is designed for indoor use only.
• Battery pack must be made by high drain current cell.
• Please contact your seller for any damage and consequent damage by misuse
• The charger should be horizontally positioned and works in well ventilated conditions, avoid wet and keep it away from flammable explosive goods.
• Don't cover the charger when charging. ambient temperature shall not be more than 40 degree C.
• Cut off the power supply before connect or disconnect the charger with batteries. Also make sure battery polarity is connected correctly
• Don't try to disassemble the charger high voltage inside, danger!