Analog 3-Axis and 4-Axis Wiring (TE-128-003 and TE-128-004)

[SuperDroidKeymaster]

Customer Question

What’s the wiring schematic for your Analog 3-Axis and 4-Axis joysticks?

Products in question:
http://www.superdroidrobots.com/shop/item.aspx/analog-3-axis-joystick/1263/
http://www.superdroidrobots.com/shop/item.aspx/analog-4-axis-joystick/1264/

The first two axis (x direction, and y direction) have standard potentiometer terminals on the sides of the joystick. The center is the wiper and the outside are ground and 5V.

For the third axis, there are a bundle of wires that run out the side. Red, white, and black. The black wire is the sweeper with red and white being your 5V and ground.

For the four axis joystick, the trigger on the top is a momentary tactile button. It’s termination are a pair of blue wires that exit the joystick with the third axis’ wires. The button is normally open and when pressed the switch closes.

Regards,
SuperDroid Robots

• This topic was modified 5 years, 7 months ago by  SuperDroid.

[Author]

Posts