Sign In

Remember Me

Roboteq Encoder Config for DG-158 Motors

Home › Forums › Electrical & Controls › Roboteq Encoder Config for DG-158 Motors



This topic contains 1 reply, has 2 voices, and was last updated by  SuperDroid 6 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 27, 2016 at 1:05 pm #3807

    5erobotics
    Participant

    Hi,
    I’m working on configuring the MDC2230 motor controller for the DG-158 Wheelchair motors with the 500cpr encoder installed in place of the brakes. Based on my calculations the motor should run at 13125 CPR (Counts per revolution of the drive shaft) or 52500 PPR but the Roboteq controller is limited to 5000 PPR in the configuration. Any idea how to approach this? or just use the control for the motor itself rather than the output shaft?

    September 27, 2016 at 1:33 pm #3808

    SuperDroid
    Keymaster

    Hi,

    Thanks for your question.

    We have a forum post that should help you out: Speed controller with encoder input

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.
Skip to toolbar