Click on images for larger views
�	�
Magnevation Dual 3 Amp PWM	Magnevation Dual 3 Amp PWM	Magnevation Dual PWM LT

�

This is a Magnevation Dual Channel PWM (Pulse Width Modulation) Driver that easily interfaces with the OOPic. It can also be used with any other PIC that has PWM output.� It's Plug and Play for no solder operation.� Dual independent PWM Drivers designed for DC permanent magnet motors, incandescent lamps, solenoids, resistance heaters etc.� This unit operates on� 12-55 Volts DC with drive current up to 3 Amps continuous per channel.� The standard unit also includes joystick port that utilizes standard PC style joysticks.�� The Joystick can be hooked up using the joystick adaptor cable.� This unit also includes pass through connector for connecting other accessories to the system.�

�

For help selecting and wiring a motor speed controller, see our motor controller support page.

�

The LT board was just have released.� It is the same board as the standard board, but without the joystick interface, heat-sinks and option jumpers installed.� Since this board does not have these items, we can sell is cheaper if all someone needs is just for driving motors.�

• Power supply requirements - 12 to 55 volts DC 0- 3 amps per channel.
• Dual independent PWM channels, each channel is independently powered and fused� with speed, direction, brakes, thermal flag and analog output to indicate motor current.
• Based on Nation Semiconductors LMD18200T�� H-bridge Driver IC's.
• Data Pass - Thru� design allow other accessories to be connected to the OOPic.
• Break out port� allows access to all 4 analog input channels on the OOPic as well as several important digital I/O channels.
• Break Out Port also doubles as a Joystick input port utilizing standard inexpensive joysticks and back plane headers used by Personal Computers.� The Joystick can be hooked up using the joystick adaptor cable.
• Small size, same as the OOPic 3.5" X 2.0"
• Circuit Board� is manufactured and assembled in the U.S.A. and is of the highest quality.� These boards are double sided, tined and plated thru holes, with solder mask on both sides, and parts legend on the top side.� The component holes are slightly larger than most other cards on the market to allow easy changes and modification by the end user.� These Assembled� boards have been electrical tested and� visually inspected prior to shipping.

For Further details, including pin out assignments, etc see Magnevation's specification page.�

�