[phwillysParticipant]

Here is a picture of the type of tracks I made. The total weight of the robot is around 25-30 lbs.

• This reply was modified 6 months, 1 week ago by  phwillys.

Attachments:

You must be logged in to view attached files.

[phwillysParticipant]

you might want to make sure the voltage is not dropping too low when you run the motors causing the sabertooth to error out due to low voltage

[phwillysParticipant]

I also had the same question about keeping the tracks on. I copied how SuperDroid Robots did their earlier version of the LT tracks and had good luck with it. I used friction drive from lawn mower wheels and screwed cleats on each side of the track to keep it on the wheel. If you get the tension right on the tracks they do not slip either. Let me know if you want pictures and Ill try to dig them up.

[Author]

Posts