�

This cable is used to connect the OOPic to another OOPic through the networked I2C bus.� The termination cable has built in pull up terminators so that the user does not have to add a terminator to the bus.� One and only one termination cable is required per network, regardless how many OOPics are connected.

�

If more that two OOPics are going to be connected together, then the other units need to be connected by means of the network cable without the termination built in.

�

This cable connects the Data, Clock, Ground and Reset lines between each OOPic in the network.� This cable is 17.75 cm in length end to end.� This cable is made of high quality parts and is assembled in the United States.

�

For more about networking cables, see OOPic's webpage.

�