�

�

These gear motors are made with steel gears (not plastic or sintered metal).� They run great and we've tested them extensively on our All-Terrain-Robots and Vectoring Robots.� We sampled many other manufactures and the gears would strip or the windings would burn up, we had no failures with these.

�

We recommend controlling the motors with one of our motor speed controllers. See our motor controller support page for more information.� We also recommend you use our wiring kit to wire your motors to control the electronic noise generated from any DC motor.� See our motor wiring support page for more information.�

�

The table below lists its characteristics.� The images above show current and torque curves and dimensions.� These motors have a stall torque of about 75 kgf-cm!� They utilize a 1:24 gear reduction.� The gear motor is 24VDC.

�

�