Battery Terms

Terms for Batteries

SuperDroid Robots Inc.
224 Technology Park Place
Fuquay Varina, NC 27526
919-557-9162 (Phone)
775-416-2595 (Fax)

Lithium-Ion batteries or robots with Li-Ion Batteries may have shipping restrictions or additional shipping charges and typically can NOT be shipped via air freight.

SuperDroid Robots Inc will review the order and contact you if there are restrictions or additional charges.

Agreement

  • Please realize that batteries might cause damages like leaking, fire or explode when misused or defective.
  • It is your responsibility to double check and make sure your devices have necessary protection circuits.
  • When charging Battery Pack, please put battery in a fire proof container. Always charge in an isolated area, away from other flammable materials. Ex: wood bench, carpet. Never leave the battery unattended.
  • We are only responsible for the products we sell. We are NOT responsible for any damages and consequences damages by using our products.
  • Review our General Terms

Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS For NIMH BATTERIES

  • Never make wrong polarity connection when charging and discharging battery packs. Always double check polarity of battery's connector to make sure red wire to red wire and black wire to black wire.
  • Please always use a smart charger (with automatic power cut-off function ) to charging NiMH battery, charging NiMH battery without an attention may cause battery explod.
  • When charging NiMH battery, please always put the battery in a wire-proof place to avoid any accident happen.
  • Please always following specification listed on our web page to charging and discharging NiMH battery.
  • For larger battery pack ( 10Ah or larger ) , please always use a smart charger to avoid over heating which may cause the accident. NiMH batteries have higher energy than NiCd battery, but they have higher self discharging rate and shorter shelf life. Therefore, please always keep NiMH cells / battery pack in charged condition after using or before storing them.
  • Suggest you charging NiMH batteries and packs at least every six months, otherwise NiMH battery will reduce capacity or dead. For safety reason, we usually ship NiMH battery without fully charged. You must charging NiMH battery before use, and allow 3-5 cycles of charging and discharging for battery capacity to recovered.

IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS For LI-ION / POLYMER BATTERIES

  • You must read these safety instructions and warnings before using or charging your batteries.
  • Lithium Polymer and Li-ion batteries are volatile. Failure to read and follow the below instructions may result in fire, personal injury and damage to property if charged or used improperly.
  • By purchasing Lithium Polymer and Li-ion battery, the buyer assumes all risks associated with lithium batteries. If you do not agree with these conditions, please consider Nimh or Nicd battery.
  • Li-Ion and Polymer battery packs may explode and cause fire if misuse or defective. We require all Li-ion batteries packs buyers must be professionals and have capability to handle emergency.
  • Must follow our instruction exactly to control charging and discharging current.
  • When charging Battery Pack, please put battery in a fire proof container. Please don't leave battery pack and charger on the wood material or carpet and unattended.
  • Must keep Li-Ion Polymer battery pack away from children.
  • If you build your own battery pack by our battery module, please make sure to charge each module separately by using our smart charger. The purpose is to keep each battery pack balanced during charging. The PCB inside will protect this module only.
  • Never make wrong polarity connection when charging and discharging battery packs. Always double check polarity of battery's connector to make sure red wire to red wire and black wire to black wire.
  • Test battery properties is your own responsibility. Please test Li-Ion battery you bought from us before using to ensure battery can be operated properly and safely in your device.
General Guidelines and Warnings
  1. Use specific Lithium Polymer/Li-ion charger only. Do not use a NiMH or NiCd charger - Failure to do so may a cause fire, which may result in personal injury and property damage.
  2. Never charge batteries unattended. When charging LiPo/Li-ion batteries you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
  3. Some LiPo/Li-ion chargers on the market may have technical deficiencies that may cause it to charge the LiPo/Li-ion batteries incorrectly or at an improper rate. It is your responsibility solely to assure the charger you purchased works properly. Always monitor charging process to assure batteries are being charged properly. Failure to do so may result in fire.
  4. If at any time you witness a battery starting to balloon, swell up, smoke or hot, discontinue charging process immediately, disconnect the battery and observe it in a safe place for approximately 15 minutes. This may cause the battery to leak, and the reaction with air may cause the chemicals to ignite, resulting in fire.
  5. Since delayed chemical reaction can occur, it is best to observe the battery as a safety precaution. Battery observation should occur in a safe area outside of any building or vehicle and away from any combustible material.
  6. Wire lead shorts can cause fire! If you accidentally short the wires, the battery must be placed in a safe area for observation for approximately 15 minutes. Additionally, if a short occurs and contact is made with metal (such as rings on your hand), severe injuries may occur due to the conductibility of electric current.
  7. A battery can still ignite even after 10 minutes.
  8. In the event of a crash due to bad shipment or other reason, you must remove battery for observation and place in a safe open area away from any combustible material for approximately 15 minutes.
  9. If for any reason you need to cut the terminal wires, it will be necessary to cut each wire separately, ensuring the wires to not touch each other or a short may occur, potentially causing a fire.
  10. To solder a connector: Remove insulating tape of Red wire and solder to positive terminal of a connector, then remove insulating tape of Black wire and solder to the negative terminal of connector. Be careful not to short the wire lead. If you accidentally cause the battery to short, place it in a safe open space and observe the battery for approximately 15 minutes. A battery may swell or even possibly catch fire after a short time.
  11. Never store or charge battery pack inside your car in extreme temperatures, since extreme temperature could ignite fire.
  12. Never drop the batteries.
  13. We suggest you put the battery in an enclosure to protect it from damages by liquid or dropping from height accidentally.
  14. Never charge batteries unattended.
  15. Put battery in the fireproof container and charge in an isolated area, away from other flammable materials. Always have fire extinguisher for emergency use.
  16. Let battery cool down to ambient temperature before charging.
  17. Do not charge batteries packs in series. Charge each battery pack individually. Failure to do so may result in incorrect battery recognition and charging functions. Overcharging may occur and fire may be the result.
  18. When selecting the cell count or voltage for charging purposes, select the cell count and voltage as it appears on the battery label. As a safety precaution, please confirm the information printed on the battery is correct.
    19. Example The label on a 2-Cell battery pack in series will read charge as 2-Cell (7.4V), or may cause fire. You must select 2-Cell for charging. B. Example: The label on a 3-Cell battery pack in series will read charge as 3-Cell (11.1V), or may cause fire. You must select 3-Cell for charging.
    Visit Battery Category
  19. Selecting a cell count other than the one printed on the battery (always confirm label is correct), can cause fire.
  20. You must check the pack voltage before charging. Do not attempt to charge any pack if open voltage per cell is less than 3.3v
    21. Example Do not charge a 2-cell pack if below 6.6v
  21. Do not charge a 3 cell pack if below 9.9v
  22. You must select the charge rate current that does not to exceed 1C (one times the capacity of the battery). A higher setting may cause fire. The below chart is calculated at 1 x capacity of pack. Example 2000 mAh: Charge below 2.0 Amps. We strongly recommend using our Li-ion battery charger to charge our batteries.
    • 4800 mAh: Charge below 4.8 Amps
    • 5500 mAh: Charge below 5.5 Amps
    • 6150 mAh: Charge below 6.1 Amps
Storage & Transportation
  1. Store battery at room temperature between 40 and 80 degrees F for best results.
  2. Do not expose battery pack to direct sunlight (heat) for extended periods.
  3. When transporting or temporarily storing in a vehicle, temperature range should be greater than 20 degrees F but no more than 150 degrees F.
  4. Storing battery at temperatures greater than 170 degrees F for extended periods of time (more than 2 hours) may cause damage to battery and possible fire.
Caring for Battery
  1. Charge battery with good quality Lithium Polymer charger. A poor quality charger can be dangerous.
  2. Set voltage and current correctly (failure to do so can cause fire).
  3. Please check cell voltage after the first charge (See Below Chart).
    • 1-Cell: 4.2V (4.15 to 4.22)
    • 2-Cell: 8.4V (8.32 to 8.44)
    • 3-Cell: 12.6V (12.48 to 12.66)
    • 4-Cell: 16.8V (16.64 to 16.88)
    • 5-Cell: 18.5V (18.30 to 18.60)
  4. Do not discharge battery to a level below 3V per cell under load. Deep discharge below 3V per cell can deteriorate battery performance.
  5. Use caution to avoid puncture of the cell. Puncture of cells may cause a fire.
  6. Operating Charging Temperature: 32 to 113 degree F
  7. Operating Discharge Temperature: 32 to 140 degree F
    • Let battery cool down to an ambient temperature before charging.
    • During discharge and handling of batteries, do not exceed 160 degree F.
Battery Life

Batteries that lose 20% of their capacity must be removed from service and disposed of properly. Discharge the battery to 3V/Cell, making sure output wires are insulated, then wrap battery in a bag for disposal Product Warranty Product warranty is limited to original defects in material and workmanship. Warranty does not cover collateral damage. Due Misuse, abuse, incorrect charging and other inappropriate use of this product are not covered under warranty.

IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS For PRIMARY LITHUIM BATTERIES

  • This is a Non-Rechargeable Battery. Please do not recharge.
  • Do not mix lithium batteries with other types of batteries.
  • The storage area should be clean, cool (not exceeding +30 Deg C ), dry, and ventilated
  • Do not use if the battery casing is damaged
  • This is consumable battery, no return, no refund after sale. We do not responsible for any damages and consequences damages caused by misuse

SuperDroid Robots, Inc is not responsible for special incidental, or consequential damages resulting from any warranty or under any legal theory, including, but not limited to lost profits, downtime, goodwill, damage to, or replacement equipment or property, or any cost of recovering, reprogramming, or reproducing any data stored. ANY LIABILITY SHALL BE LIMITED TO REPLACEMENT OF DEFECTIVE PARTS. SuperDroid Robots, Inc. is further not responsible for any personal damages, including, but not limited to bodily and health damages resulting from any use of our products.

SuperDroid Robots, Inc. makes no representations as to the fitness of its products for specific uses. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS HEREBY EXCLUDED.

Agreements shall be construed in accordance with the laws of the State of North Carolina, and the rights and obligations created hereby shall be governed by the laws of North Carolina.

In the event a dispute or controversy arises, such dispute or controversy (including claims of default) shall be brought in the courts of Wake County, North Carolina and the plaintiff hereby agrees to this choice of venue.